Railcore® Doors Hardware so you can easily change

so you can easily change nozzles without tools or hot tightening at room temperature

The Acrylic Side Panels are finally listed

which is not long enough to cause heater faults or even heat up the wrench enough to get to where you hand is holding it

The bed is made from 6

Railcore® Doors Hardware so you can easily changeWe now have Polycarbonate as an option as well! Want to add that extra "thing" to your Railcore II 300zl, or maybe just have something to block those little fingers? Add some doors to your printer! You have the choice between smokey grey or clear acrylic. The doors are designed by J. Steve White and are designed to go flush with the outside of the printer, not inside the cutout. The hardware kit can be downloaded from thingiverse at: https: www.