Voron 250 Bed Bed Options:Ultraflat - No Magnets These bearing blocks are to

These bearing blocks are to help constrain the leadscrew at the bottom of the printer near the coupler

This plate is for integration of open5x on the mod0 printer from Brendon Builds

3 Pin Mounts

We also check each bed on a granite surface plate to make sure it is within specs for use on your printer

Voron 250 Bed Bed Options:Ultraflat - No Magnets These bearing blocks are toWe offer these in standard or magbed versions. Our magbeds are a top magnet design bed, meaning that the magnets are slightly below the surface of the magbed. This gives a very superior holding power, however, it does require a very good quality build plate, such as Buildtak or KB3Ds. The manufacturers of those flex plates use a 0. 5mm thick sheet. Thinner sheets may dimple slightly under the magnet. A lot of China build plates are not up to the