SpeedFactory Racing Stainless Steel K-Series Intake Manifold Stud Kit Stud Length:55mm (2) -10AN weld fittings on

(2) -10AN weld fittings on the upper left side

If using an ’00 outer transmission case that had a straight reverse shaft with the SFR Billet Bellhousing then you will need our custom offset reverse shaft PN# SF-05-601-RS to properly locate the reverse idler gear and for the cases to close properly

I noticed that the FWD input shaft is a bit shorter than the AWD input shaft

often bending even in stock transmissions and are too thin for use with a FWD 1/2 slider

SpeedFactory Racing Stainless Steel K-Series Intake Manifold Stud Kit Stud Length:55mm (2) -10AN weld fittings onIntroducing a new, cost effective yet still high performance alternative to our Titanium Stud Kits! Our high quality stainless stud kits look great and allow you to properly clamp your intake or exhaust manifold to the cylinder head without experiencing sealing problems. They are significantly stronger than your stock bolts & studs, and you will no longer have to deal with ugly and troublesome rust & corrosion. These stud kits incorporate a hex key